Seagull Models Funfly 3D Especificaciones descargar pdf (Pagina 20)

SEAGULL FUNFLY 3D. Instruction Manual.

20

ELEVATOR AND RUDDER

PUSHROD HORN INSTALLATION.

 1) Install the elevator control horn using

the same method as with the aileron control

horns.

 2) Position the elevator control horn on

the both side of elevator.

 6) When you are sure that everything is

aligned correctly, mix up a generous amount of

Flash 30 Minute Epoxy. Apply a thin layer to the

mounting slot in the top of the fuselage and to

the sides and bottom of the vertical stabilizer

mounting area. Apply epoxy to the bottom and

top edges of the filler block and to the lower

hinge also. Set the stabilizer in place and re-

align. Double check all of your measurements

once more before the epoxy cures. Hold the

stabilizer in place with T-pins or masking tape

and remove any excess epoxy using a paper

towel and rubbing alcohol. Allow the epoxy to

fully cure before proceeding.

C/A glue.

Hinge.

4) Elevator and rudder pushrods assembly

as pictures below.

3) Thread one clevis and M3 lock nut on

to each elevator control rod. Thread the horns

on until they are flush with the ends of the con-

trol rods.

M3 lock nut.

M3 clevis.

90mm.

120mm.

Rudder control horn.

Elevator control horn.

Elevator pushrod.

Elevator control horn.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios